Search Frequent Questions

Filter By:

Active filters:

Remove all filters

Displaying 1 - 15 of 45 results

  • Where can I find older NEI data (prior to 2008)?

    The raw data and summaries that are still available (dating back to 1990) can be obtained from the web page https://www.epa.gov/air-emissions-inventories/pollutant-emissions-summary-files-earlier-neis . Starting with 2001 data, a more limited selection of summary files are available.

    • Last published:

  • Hot Work Definition and Requirements

    Facilities subject to the Program 3 Prevention Program requirements in 40 CFR Part 68 must include in their Risk Management Plan the date of the most recent review or revision of hot work permit procedures in Section 7.13. What is considered hot work and what are the requirements related to…

    • Last published:

  • Do I have to conduct incident investigations of releases resulting from theft?

    The incident investigation provisions of 40 CFR Part 68 (§§68.60 and 68.81) require facilities to investigate incidents that resulted in or could reasonably have resulted in a catastrophic release. Are covered facilities required to perform incident investigations of releases resulting from theft of covered substances, such as anhydrous ammonia? If…

    • Last published:

  • Do Program 1 processes have to complete a process hazard analysis?

    Do owners or operators of Program 1 processes have to complete a process hazard analysis? No. The Program 1 requirements do not include a process hazard analysis (40 CFR §68.12(b)). Program 3 processes require completion of a process hazard analysis (40 CFR §68.12(d)(3)) while Program 2 processes must complete a…

    • Last published:

  • Is a hazard review synonymous with a process hazard analysis (PHA)?

    The prevention program requirements under 40 CFR Part 68, Subparts C and D, include hazard reviews and process hazard analyses. Is a hazard review synonymous with a process hazard analysis (PHA)? No. A hazard review is different from a PHA. A hazard review is part of the Program 2 prevention…

    • Last published:

  • How often must compliance audits be performed?

    How often must owners or operators of stationary sources subject to the risk management program regulations perform compliance audits? The regulations at 40 CFR §§68.58(a) and 68.79(a) state that owners or operators must certify that they have evaluated compliance with the applicable prevention program provisions at least once every three…

    • Last published:

  • Will there be an increase in turbidity (cloudiness or muddiness) or silt in the streams?

    The increased flow from this work is expected to be minimal and should not impact turbidity or silt.

    • Last published:

  • Will returning the natural flow of water to Sulphur Run disturb areas with sheen?

    Conditions in the streams are much improved because of previous cleanup work conducted in 2023. Although oily sheens remain, they are settled in the sediment and do not impact surface water unless disturbed. The increased water flow to Sulphur Run will be minimal and is not expected to disturb sheen…

    • Last published:

  • Does compliance under OSHA's PSM demonstrate compliance with the risk management program?

    The Clean Air Act Amendments of 1990 (CAAA) mandated the Occupational Safety and Health Administration (OSHA) to develop a regulatory program to protect workers from the risk of accidents that involve hazardous chemicals. OSHA promulgated its Process Safety Management Standard (PSM) on February 24, 1992 (57 FR 6356), codified at…

    • Last published:

  • Applicability of compliance audit provisions to non-prevention program elements

    I have a Program 2 covered process and a Program 3 covered process at my stationary source. I am required (by 40 CFR Section 68.58 and 40 CFR Section 68.79) to certify compliance with prevention program requirements every three years. These compliance audits specifically address the prevention program portions of…

    • Last published:

  • Does a five-year update satisfy the requirement to conduct a compliance audit?

    The owner or operator of a stationary source with a Program 2 or Program 3 process must conduct a compliance audit at least every three years to ensure compliance with the prevention program requirements and must revise and update the risk management plan (RMP) at least every five years (§§68.58…

    • Last published:

  • RMP Program Level 2 and 3 compliance audit frequency

    Pursuant to the risk management program regulations, facilities with Program Level 2 and 3 processes must perform compliance audits at least once every three years (40 CFR §§68.58 and 68.79). Do regulated facilities have to perform the audits within exactly three years or can facilities perform the audits any time…

    • Last published:

  • Does a PHA for OSHA satisfy EPA's PHA requirement for Program 3?

    The risk management program regulations require that an initial process hazard analysis (PHA) for each Program 3 process be completed no later than June 21, 1999 (or by the time the process first has more than a threshold quantity of a regulated substance, if that occurs after June 21, 1999)…

    • Last published:

  • Do compliance audits cover non-prevention program requirements?

    Does the compliance audit requirement cover all of the Part 68 requirements or just the prevention program requirements? The compliance audit requirement applies only to the prevention programs under Subpart C. If you have a Program 2 process, you must certify that you have evaluated compliance with the Program 2…

    • Last published:

  • How often must employees complete refresher training?

    How often must employees of facilities that are subject to the risk management program complete refresher training? A facility owner or operator must provide refresher training at least every three years, and more often if necessary, to each employee operating a process in order to ensure that the employee understands…

    • Last published: